![]() Caution: do not drill into the wall above or next to electrical outlets, as you may run into an electrical cable.īefore you start drilling, you need to think about the size of the hole. It is best to take some time and mark the position of the box on the wall with a pencil. Depending on the type of appliance you want to fit in the box, you may need a larger or smaller box.īefore you start drilling, you need to think about where you want to install the back box. However, it is not so difficult if you follow a few tips and tricks.īefore you start installing the back box, you should first consider the size and design of the box. Beginners in particular are often overwhelmed and fail. Tips and tricks: how to install successfully?įor many do-it-yourselfers, installing flush-mounted boxes is a big challenge. Good plastering warning covers help to find the box if the wall is still being plastered. Finally, plaster, glue or screw the box in place and check once again that everything is secure. ![]() When the hole is large enough, carefully insert the back box into the opening and press it lightly into place. Drill the hole carefully and slowly so as not to damage the wall. Ideally, it should have a diameter of about 3 cm.Īfter marking the hole, you can start drilling. Make sure that the hole is neither too large nor too small. You can use a pencil or a biro for this purpose. Before you start drilling, you should therefore mark a hole in the wall. The drilling in the wall must be precise so that the back box can be inserted properly. This will ensure that everything is done correctly. Even if you install the flush-mounted boxes yourself, it is advisable to seek professional advice beforehand. In addition to a drill and a suitable drill bit, this includes a plastering trowel as well as fine sandpaper and abrasive fleece. It’s all about preparation: the right tools and materialsīefore you start installing the back boxes, you must first get the necessary tools and materials. It can be used to connect electrical and telephone cables and offers a safe and orderly way to connect electrical appliances to the power supply. The flush-mounted box is also used for the installation of switches and lights.īut the flush-mounted box is also a switching point that is built into the wall and serves as a connection point for electrical cables. It is therefore particularly important for the installation of switches and sockets. The box serves as a connection point for the wiring and is designed so that it can be built into the wall. The flush-mounted box is an important element in the installation of electrical appliances. But it’s not that difficult – we’ll show you how! What exactly is a back box? Many people are reluctant to get down to work when it comes to installing flush-mounted boxes.
0 Comments
Leave a Reply. |